Table of Contents
Height Adjustable Chairs might be an essential part of our workspaces and home setups. But, with prolonged use, you may meet several issues with the chair and need to replace or repair your chair. One of the common but challenging tasks is separating the gas lift from either the tilt mechanism or the wheelbase. This thing may be a nightmare before to you. But don't worry! In this article, let's find out how to separate them easily and quickly.
First, you need to prepare the below Tools:
- Soft Cloth or Towel; Or looking for a clean area
- Protective Gloves
- Split Shaft Collar*2
- Allen Key*1
- Lubricant (e.g., WD-40)
Steps to Follow:
- Choose a flat, stable surface — Ensure you have enough space to work comfortably. Lay down a soft cloth or towel to protect the floor and the chair parts from damage.
- Wear protective gear — Gloves will protect your hands from sharp edges or grease, ensuring a safer and cleaner repair process.
Once prepared, you’ll be ready to proceed with separating the gas lift. Follow these steps below to maintain the task:
Gas Lift and Tilt Mechanism Separation Tool Instruction
Step 1: Fully extend the cylinder, clean the grease off with a napkin the chair onto its side.
Step 2: Attach the small solid ring(no side screw holes)close to the mechanism. This collar must be loose, able to slide up and down.
Step 3: Attach the small ring with holes on the side, Ensure this is screwed tight, It must not able to move.
Step 4: Insert the long screws into the holes one the side of the cuff from the bottom up. Tighten evenly and alternately. This will push the top collar up and detach the gas cylinder from the mechanism.
Step 5: Takethe tools away.
Step 6: Carefully pull the gas lift out.
Gas Lift and Wheelbase Separation Tool Instruction
Step 1: Place the base on the floor.
Step 2: Remove the gas cover if there is one.
Step 3: Attach the large solid ring(A) (no side screw holes)close to the base. This collar must be loose, able to slide up and down.
Step 4: Attach the large ring with holes on the side, Ensure this is screwed tight, It must not be able to move.
Step 5: Insert the long screws into the holes one the side of the cuff from the top down. Tighten evenly and alternately. This will push the bottom collar down and detach the base from the gas cylinder.
Important Considerations
Protect the surfaces: Use a cloth or protective material to prevent damage to the chair's components.
Check for wear and tear: Inspect the gas lift and base for any signs of damage or excessive wear before attempting to separate them.
Consult the manufacturer's instructions: Always refer to your chair's specific manual for the correct disassembly procedure, as mechanisms may vary between different models.
Conclusion
By following these steps, you can successfully separate a gas lift from the tilt mechanism or wheelbase, allowing you to repair or upgrade your office chair. Regular maintenance can extend the life of your chair and ensure it remains comfortable and functional for years to come.
